So I’ve been doing some tests with some materials I had laying around and this morning I had a tattoo cancellation so decided to give a burnt wood scent to my studio and here is what I managed.
It is not the cleanest of all cuts… but it did cut.
So I’ll do some more tests.
Btw only had to pass about 9 times on the same spot:joy:
There is no telling what woods and glues were in that piece.
Yeah, that looks like it would be tough to cut through too! Good job on it.
It would be worth exploring the safety of using OSB with a laser. Assuming it’s not going to burn your house down or fill it with toxic gas, you can do some interesting stuff with OSB.