15" and 17" Laptop Stand


#1

completed my version 1.5 of the Fusion 360 laptop stand tutorial tonight. i say 1.5 because my first draft was too large to fit my 15" macbook and barely worked for my 17". so i went back into fusion, adjusted the width of the stand and reprinted the top and support pieces. i am quite pleased with myself. tomorrow i want to add some embellishments to the top and sides.

in case any one is interested the tutorial i followed and then tweaked to my tastes can be found here


#2

Very nice! :grinning:


#3

Great job! I want to make something similar, but a bit more vertical, for my iPad.