Camera didn't take a picture Message

I was using my machine as usual this morning, and in between swapping boards something went wrong and my forge stopped working properly. I keep getting the camera didn’t take a picture message. I went through all the suggested steps. I also reset my wifi and my computer. Checked and re Checked the connections to the cables. The bed will not refresh despite all of this. It still shows my last piece of wood on the bed.
I contacted customer support but I was hoping someone could help me out here while I wait…

Hi @amandahanson1080. I see you already emailed us about this and we’re working on it there, so I’m going to close this topic. I just sent an email response to that thread, and will look forward to your response. Thank you!