Camera is off center, not showing entire piece of PG acrylic

I turned on my Glowforge today, for the first time in awhile. I simply want to print a triangle but when I upload my image (SVG format), and the screen goes to the bed of my glow forge, only about 2/3 of the PG acrylic shows. It also says no artwork even though I have opened my file and it shows on the screen. Can someone please help me? I am not an experience Glowforge user quite yet so I am hoping it is something easy.

I guess 2/3 shows is wrong. It shows almost the entire piece of acrylic.

1 Like

The left edge of the cut area is just a little past 0 (0.034") and your design goes way beyond that.

Read this.
https://community.glowforge.com/t/camera-not-showing-whole-material/115118/5

6 Likes

If any of your artwork is outside of the usable area of the bed, you will get the “no artwork” message. Orient your artwork relative to the lower right corner. The cutable area is approximately 10.9" x 19.5".

6 Likes

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.