I am not sure if this the correct thread for this question so please forgive me if I am in the wrong place. When I am cutting a small piece like a honeycomb pin is the a way to repeat the artwork so I can cut more than one at a time … like a copy paste?
I can right click and copy but where is the paste?
Thank you!
On windows: cntl-c=copy, cntl-v =paste
On mac, same but use command instead of control.
Awwww … I should have known that. Thank you so much!
It’s much easier to do that in your favorite vector editor. Open it in inkscape, copy paste (better yet, clone) arrange them, then load it into the UI, with as many copies as you wanted ready to go.
Thank you @ evansd2