Hi guys, first post here. Have had my Glowforge Pro for about a month, and have been keeping it going quite a bit. Im always working on projects for friends and family so I thought Id share how I’ve been using my Glowforge Pro.
First project is a set of corn hole boards I did for a friends bday gift.
was able to fit the art in 2 sections, but the lining wasn’t terrible, but could be better.
Next is a pair of Adirondack chairs for my grandparents, pretty straight forward. Didn’t use the laser for the chair just the front panel board.
next is an entry way table / buffet, used the laser for the side pieces. Wish I didn’t have to put a backing on it but the 1/4" wood wasn’t sturdy enough.
Finally a trophy and plaque order I’m wrapping up. For the trophies, I etched each outline of the main wood then used that as a guide on the bandsaw. The acrylic on the front was etched and cut on the laser (took about 15 min each) and the mirrored acrylic turned out much better than I thought It would.