Error in recognizing art resulting in no cuts

Yep. You whippersnappers don’t know what it was like lasering in the old days (Pre-GF) :grin: Risked life & limb (& eyeballs) we did, aye up.

3 Likes

Mirror alignment round one: well, the laser is on but, I don’t see any marks appearing on the tape … wait … what’s that smell?

2 Likes

Sunvab’ that hurts! :stuck_out_tongue_winking_eye:

1 Like

I’m so sorry for the delay in response, and thanks for the help @ bansai8creations! I’m glad the issue with the print time was fixed.

@ drink I am curious about the trouble you had with Set Focus, and I’d be happy to look into it. Can you tell me more about the problem you had?

It’s been a little while since I’ve seen any replies on this thread so I’m going to close it. If you still need help with this please either start a new thread or email support@glowforge.com.