First project - box

Made on a Glowforge
#1

I had to redo three sections because I did not notice two of them were upside down and one was not dark enough!
I did this for a friend into D&D20180802_234349

20180802_234313
20180802_234313.jpg1333Ɨ750 298 KB
20180802_234304
20180802_234304.jpg1333Ɨ750 292 KB
20180802_234428|690x388
20180802_234405
20180802_234405.jpg1333Ɨ750 318 KB
20180802_234333
20180802_234333.jpg1333Ɨ750 295 KB

27 Likes
#2

Very nice results! The engraves are nice and dark! :grinning:

2 Likes
#3

I too printed upside down on my first one. Looks good.

2 Likes
#4

Iā€™m sure you had a lot of fun! Also ā€¦ that they loved it!