Flame polishing on the GF - How?

Beyond the Manual
1

Cutting acrylic I still get very fine cut marks from the stepper motors, especially on curves.

I’ve found all the pre-shipping discussions about defocussing to achieve flame polished edges - but I can’t find anything about it since the GF started shipping.

Anybody doing it ? Got any tips, settings or advice? I’m using regular 3mm laser acrylic.

1 Like
2

I would think you just run the same line you just cut but slightly defocused? Haven’t tried it, don’t recall anyone posting specifically about it.

3

We have used flame polishing to increase clarity but not for contour of edges.