I want the app to . .

I was using my GF to make stickers out of duct tape. On the left side of the picture you can see 2 figures already cut out. The artwork had to be scaled slightly to fit the width of the tape. I also had to manually set the laser settings since the tape is not proof grade.

I would like to copy artwork and paste it multiple times rather than having to import it several times to make the same item in multiple locations. When coping please copy the laser settings and current size/orientation.

Maybe this is already possible. I could not figure it out.

Just select the asset, and use control or command-c to copy. And then control or command-v to paste it.

6 Likes

What @jbmanning5 said, but if you really want tight control, edit it in your favorite vector app and get your alignment and scaling right there first. You’ll always have more control that way.

2 Likes

Did you test the Duct tape for Vinyl?

Thanks for the pointer @jbmanning5. I’m going to close this thread - if you have another question, go ahead and post a new topic. Thanks for letting us know about this!