My wife asked for a stand that would allow her to stand her IPad up vertically but allow her to charge it while using it. She wanted the button on the bottom. I made her two one practical and one a little more whimsical. Both done in Inkscape.
44 Likes
Nice design! 
They look great!
I don’t see the file. Did you mean to post this on Made On A Glowforge? If so, I can move it for you.
2 Likes
I am having a problem loading the files. ?
I posted them as pdf and that worked . I tried both Inkscape svg and plain svg and neither would post.
2 Likes
Thank you!
1 Like
The SVG files are there in the original and in your repost. They’re just really small, you can edit the post and change the size if you like.
I do not know how to make them larger. Any help in doing this for future reference.
IPad Holder|20x12](upload://rOUIsQ7afZyOvlWyPBa3iPvp3C4.svg)
When you upload, where it says 20x12 just above here, change those numbers. At the top I put 200x120 and just under it I made it 400x240 (being lazy, I just multipled by 10 and then doubled to keep the dimensions in the appropriate ratios)
5 Likes
That’s how I usually do it.
Except being lazier, I tend to stop after the “multiply by 10” step 
3 Likes
I’ll use the “illustrative purposes” defense 
1 Like
Thank you I will do that in the future.