iPhone stand

I can’t take a picture of my phone on it because I’m using my phone to take the picture. But it came out very pretty, and it only took me about half an hour to design in OnShape. I previously made little kerf-testing octagons for MDF and acrylic, so I could dial in the kerf settings fast. It’s not glued at all - just friction fit - but the fit is pretty tight. I’m definitely not worried about it falling apart in my office.


(Please ignore all the junk on my desk.)

16 Likes

What junk? :wink:
Very nice, and it’s great that you have kerfing pre-determined for acrylics - I need to do that one of these days. :slightly_smiling_face::+1:

I am using 0.007", and it fit tight enough to not need glue. So I would recommend starting with that.

3 Likes

AND it is clear so the Useful Stuff behind it is not hidden.
Good job.

1 Like