Is anything Wonky tonight?

ca_worth · February 12, 2020, 1:54am

I can upload but BEAMER is taking forever to Center and home etc.

then I got an error.

robermar36 · February 12, 2020, 2:04am

Mine had to center twice before she was ready…weird

eflyguy · February 12, 2020, 2:11am

Been using it most of the evening without issue, but shut it down about 30min ago.

Jules · February 12, 2020, 2:18am

Can’t use mine till tomorrow… she had a bath tonight.

johnj · February 12, 2020, 2:38am

Ive been using mine most of the evening but the last upload was an hour ago. Right now its printing.

ca_worth · February 12, 2020, 5:29am

Well it got going and the outline of Jamaica was successfully created

BiggestLittlePaperCo · February 12, 2020, 5:59am

I can upload but i can’t select whether or not i want to engrave or cut and i can’t change any of the settings.

theroar84 · February 12, 2020, 3:37pm

I have been having scanning and centering issues for 2 days now. =( I double check that everything is clean. At the moment I have to shut off, move to center, power on between prints.

GaryW · February 12, 2020, 5:19pm

I’m so glad to hear that you were able to print the outline of Jamaica successfully! We’re not aware of any outages at the time you posted. Since you’re printing successfully, I’m going to close this thread.

@theroar84 and @BiggestLittlePaperCo I’m so sorry to hear you’ve been having these issues. We’re only able to assist one person per thread. Please either start a new thread or email support@glowforge.com.