Start by adding shims under the left front corner or right rear or maybe both.
Hehe, yeah. I got fed with smelling up the shop and spent an afternoon attacking every joint seam and screw in my long run to the adjacent furnace room.
But my installation is proof odorless can be done - as long as the machine is breathing right.
I don’t think that extra length on the vent hose is hurting you, compressed like that it is probably less turbulent-inducing than if it were stretched out.
4 Likes
This is amazing! I ran a few cuts this afternoon after I leveled the laser with a stack of paper and no smell! I was thrilled to pieces!!
8 Likes
I know right? I was too!
1 Like
Worked for me
1 Like
This topic was automatically closed 32 days after the last reply. New replies are no longer allowed.