Printing around 9:20 and 9:30 PM, Eastern Time, 11/4/2018.
Follow up burn on same image. No moving item, no moving image, change to LPI, but no change to position, focus, etc.
The second run is VERY far off the original. (The diameter of a dime at the farthest extent, and rotated to boot). The original image is also at least 1/4" off the original orientation in the GFUI.
I’m glad you resolved it! I’m going to close this thread. If you run into any other trouble, please start a new topic, or email us at support@glowforge.com. We’re here to help!