Is there a way to correct for the distortion of the lid camera? It’s pretty obvious that it’s not quite right:
It would be nice to be able to position new art over board remnants and have a good chance of it fitting.
Is there a way to correct for the distortion of the lid camera? It’s pretty obvious that it’s not quite right:
It would be nice to be able to position new art over board remnants and have a good chance of it fitting.
Welcome @mike.wessler What @chris1 said. I ran the camera calibration and it is amazing. Usually well within 1mm now.
BTW, this forum is an amazing source of information. Have a look around and you will probably find what you are looking for. If you can’t find the answer there are many helpful people here.