Logo inlay on custom guitar

tbruthardt · February 6, 2018, 4:47pm

If I could possibly cut the indexing pin holes to match my fret board slotting jig I might be able to do all the inlay work first, then cut the fret board out.

xkgix · February 6, 2018, 8:40pm

Good idea! I guess trial and error is what it’s all about but I think it will work. I assume Red Layer Guitars laser cuts their inlays and guitar tops. Take a look at their stuff.

VIP · March 26, 2018, 6:20pm

What is the exact number on the 3M adhesive? I ordered some 3M 467MP (200 MP) and, although it works, it doesn’t seem to be the same stuff (the 467 is hard to peel).

Great work!

tbruthardt · March 30, 2018, 2:19pm

Sheet of 3M 9474LE 300LSE super-strong double-sided adhesive/adhesive transfer tape of size 8" x 12". Economy packaging without stiffener [3M9474-08x12] https://www.amazon.com/dp/B00CCGK31G/ref=cm_sw_r_cp_apa_SCKVAbAQ416NQ

VIP · March 30, 2018, 6:35pm

Thanks! I appreciate it!

Paulk · March 31, 2018, 4:40pm

That’s some beautiful work there!

tbruthardt · April 1, 2018, 4:50am

Thanks!!!

tbruthardt · March 18, 2019, 5:01am

Hey, I just posted a Pic of an inlayed fretboard I did recently. I’d live to share detailed method when you’re ready to do one!.