I hope this hasn’t been covered already, I did search for it but couldn’t find anything. I have the pattern for the miracle hinge coffee sleeve but when I open it there’s no artwork. It’s blank? I’ve printed it before, I’m not sure what happened since then. I’m assuming I did something I wasn’t suppose to (like delete it) but how do I get it back?
Things I’ve already tried: Restarting my browser. Using a different browser. Restarting my computer and my GF. (Not sure why that would matter but try everything right?)
When looking at the blank printer bed after opening the design, click the dot dot dot button at the top. There should be a “reset design” button in the right side panel.
Omg I’m an idiot. Thanks for being so fast!
nah, it’s not particularly intuitive… but now you know!
Nah. It’s apparent from the forums that this is not intuitive. Even finding the assembly instructions isn’t that easy (same spot).
I’m going to close this thread - if you run into anything else, please go ahead and post a new topic. Thanks for letting us know about this!