Hello,
first time posting. A bit of a newb. I teach STEM to Elementary kiddos. My GF tube went crooked after a job and now its cut lines are not in sync with the score lines (see pic). Using SVG files. I tried to straighten it out the best I could, turned off/on, tried a job, but cut lines shift and I’m not sure why. Any help is greatly appreciated!
Assuming you mean the gantry that carries the tube, there are instructions on how to square it up in the support pages. Link at the top of every forum page.
4 Likes
Welcome to the forum.
See if either of these steps help you: https://support.glowforge.com/hc/en-us/articles/4466641175835-Laser-Arm-Derailed
5 Likes
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.