No Artwork Error

Community Support
1

The No Artwork Error is cryptic and confusing. It seems to appear when:

  1. Artwork extends outside the working boundaries of Glowforge
  2. When the Engraving speed is too high for a number of conditions.

Question 1) Are there plans to make this error message more specific?
Question 2) Is there a definitive list of what might cause this error message?

Thanks,

2

The other instance it shows up is if you haven’t defined any operations yet and you’re not using proofgrade materials.

1 Like
3

THanks, I haven’t seen that one yet.

4

The first time is enough to drive you crazy because you can have it all in the center & you’re saying to yourself “it’s right there and it’s small and fits”. Then someone tells you to make sure it has an operation (cut or engrave) so the GF can determine it it’s within the bed limits. It’s obvious to us because we can see it but the software can’t.

1 Like
5

I’m going to close this thread - if the problem reoccurs, go ahead and post a new topic. Thanks for letting us know about this!