Pausing a print

qa

#1

Will the GF have the ability to pause in the middle of a print, open the lid, then close the lid and continue?

While making coasters from Sandstone at my local Makerspace (Epilog Laser Cutter), I noticed an odd little ‘cotton’ looking glob building up. I think it was remnants of the sand being vaporized by the laser. It would fall on to the middle of the piece and prevent the laser from etching in that area. I had to pause the process, remove it, and continue… Just wondering if the GF will allow for this?


#2

I believe yes. From what I have read it will even pause if you open the lid(safety feature) and then you could resume the print after.