Photo Settings


#1

I thought the photo settings were being updated for PG materials?
Putting in maple hard wood both the HD and draft photo settings are just full speed, full power. This creates pretty terrible prints.
Am I missing something or is something not updated properly ?


#2

Yes, I believe there is a typo in the HD photo settings for Maple Hardwood. The LPI is probably correct but don’t think the power and speed were changed from a draft setting. You can look at both Cherry and Walnut to get an idea of an appropriate range for HD photo. Maple HD will be different than those but not full/full.

Disclaimer: Haven’t tested, and likely won’t until I have something worthy of wasting the material.


#3

Thank you so much for the details. I’m looking into it now. As soon as I have more information I’ll update this thread.


#4

I looked into these settings, and verified they are correct.

I’m going to close this thread - if you have any additional questions, go ahead and post a new topic.


#5