After a project is completed the bed image remains. The three dots on the task bar for gf has a category for bed image but doesn’t highlight thus not allowing its use. Suggestions on removing the bed image?
1 Like
Welcome to the community! Not sure what you mean by bed image. Are you meaning the last project you printed? If that’s what you mean, you can go back to the dashboard…then your next project will start with a fresh image.
6 Likes
If you mean the image of your last project is still showing on the bed - if you let the laser refresh the image before you finish for the day, you’ll come back to a blank (or at least, whatever is in your laser). The 3 dot refresh only works if the laser is on and connected (and not actively in a refresh or focus cycle).
7 Likes
Welcome to the forum.
If you cannot get the bed image to refresh with the machine turned on, you are offline.
5 Likes
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.