Slow start up

Its taking time to home. I have been waiting for 15mins, but still homing.

I checked the below link, but there is no problem.

Turn it off. Take everything off of the bed. Make sure the lid camera is clean. Make sure the top of the printhead is clean. Gently position the printhead directly under the lid camera. Turn the machine back on.


Thank you for your quick reply. I’m gonna clean everything.

Hope it works.

Thank you very much! It works


I’m so about the trouble you’ve experienced, but I’m glad that the advice @dklgood provided was helpful, and everything is now working.

I’ll close this thread for now, but please don’t hesitate to reach out to us in the future if you run into any more trouble, and we’d be more than happy to help :slight_smile: