I had a file lined up incorrectly after sending the job to the ol forge. I hadn’t hit the shiny button yet and it was processing the job. I hit cancel and it said cancelling. It has been a few hours now and still on cancelling. I tried clearing the cache, cookies, powering off and on, rebooted the computer, checked my wifi. I just can’t clear it. Any tips?
1 Like
nevermind…I tried holding the start button while powering it up and kept holding it. The light turned purple and then turned off the light. It’s back to normal again. Whew!
2 Likes
@joshnmary484 I’m glad to hear your back up and printing! I’m going to close this thread - if the problem reoccurs, go ahead and post a new topic.
1 Like