Hi, Looking for advice on how to size an image so that it’s larger than the standard size material, and cutting it in sections that can be pieced together. Wondering if there are any tricks to moving the image each time so that the tiles match up accurately?
Thanks!
There are some good answers here: Search results for 'tile image' - Glowforge Owners Forum
It will depend on your software - some of the ones that start as questions have answers in the replies so don’t skip over those 
@michele1 Welcome to the forum!
Thanks, @deirdrebeth for the suggestions those look great!
I’m going to move this post to allow other suggestions and advice. Normally for posts in problems and support, we close them out once we’ve responded, but our community forum might have some additional suggestions to help you out.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.