Wow this looks great. Thank you for testing this. Could you give any hints about the dimensions (z = 0.433" /> 1cm) and how long does it take to cut such a piece? Just a rough estimate would be fine. Are we talking about seconds or minutes?
The cut is a smooth square 2-3/4" on a side. There is also a small nut shaped cut in the center. For 1/8" Proofgrade Maple the two cuts would have taken 30 seconds. With the much slower speed required for a .433 Oak board, it took 1 min 44 seconds.
The settings have changed so old numbers no longer apply. Can’t remember anyway. It was a Pro tube. Full power at the time and extremely slow. I might try to replicate it tonight. Still have a section of the same board.