Winter hiatus and my Glowforge works like new

Winter is almost over in Chicagoland, just waiting for the final April snowstorm.
I unwrapped the GlowForge’s winter blanket and removed my GlowForge’s heater and temp. monitor; then raised my exhaust slider…

Started the GF and set up some prints with Draft Board and another one using Acrylic , all cuts, engraves, and scores worked great.

21 Likes

Feed it grubs and berries after its long hibernation! :bear:

:slight_smile:

5 Likes

This topic was automatically closed 32 days after the last reply. New replies are no longer allowed.