Very cool looking! I wonder if it could work using this design so the living hinge part would not show anywhere and apparently solid wood disappeared off to the side.
I was thinking in terms of an exhaust port idea, but there are many possible uses for this. You will need real plywood with wood all the way through and no MDF and try to make sure it is clean. I have bent quarter inch oak ply this way, but baltic birch should work as well
You will want to engrave the blue as deep as possible without going through, ideally leaving only a single ply. Then the whole thing left in a plastic bag with excess alcohol hand cleaner for 2 days. While still in the bag sl…
It might not make as sharp a turn.
2 Likes