Magnets

[Jules]

You can try magnets, but you might get an error message about the air assist, and the machine will stop if you place strong magnets too close to where the head is going to be moving.

I prefer not to use them. A better thing to use is the Honeycomb Pins here:

Honeycomb bed holdown pins

the best laser results are achieved with flat (non warping materials) in order to maintain consistent focus. Also, when cutting light materials like paper, the exhaust turbulence can kick up the material and ruin your job or at worst… catch fire. (speaking of which, I hope you all keep a small fire extinguisher in easy reach, near your machine - safety FIRST) I hope you find these useful. I used to 3d print them for my other laser cutter but occasionally , they would see the wrath of the laser …