Metric and Imperial Ruler (30 CM/300 MM/12" Inch ruler)

[eflyguy]

The file says Illustrator, so…

[rbtdanforth]

@bufuteeth

What program did you use

If you set Inkscape in a strong snap it is very easy to set the marks at what the snap is.

I did these

Two sticks to rule the world

Well, the world inside a Glowforge anyway! Having some scrap plywood I thought to make a 20-inch ruler that would define the space available and set accurate measuring points, I set Inkscape with a 1/10-inch grid and a snap-to-grid so they were dead on accurate and as I was doing it realized that I could not engrave or even cut the full length, so I measured a horizontal line as close as I could get to the max cut area, and cut the rulers down to that. I could not decide which side to put the i…

[redsall]

That’s funny right there now!

[Jules]

I never caught that!