Printing ruler problems

[rbtdanforth]

@bufuteeth

I generated a ruler measured in inches and it worked fine. I guess I’ll just buy a metric ruler.

or you could try…

Two sticks to rule the world

Well, the world inside a Glowforge anyway! Having some scrap plywood I thought to make a 20-inch ruler that would define the space available and set accurate measuring points, I set Inkscape with a 1/10-inch grid and a snap-to-grid so they were dead on accurate and as I was doing it realized that I could not engrave or even cut the full length, so I measured a horizontal line as close as I could get to the max cut area, and cut the rulers down to that. I could not decide which side to put the i…