Glowforge Owners Forum

Rotary?

Everything Else

rebecca October 9, 2020, 1:20am 3

Welcome to the forum!

There have been some homemade tools.

Here’s one from @karaelena

Pre-Release | Manual Rotary Indexer Made on a Glowforge

Supplies: 1 1/4" (19.05mm) Dowel, Acrylic & Cardboard - Op Time : 29 mins I had this idea kicking around for a while. I had a couple hours today so I tried it out. After about 30 mins in F360 I had this. [image] Exported out the parts I need to AI. Then started to cut. First with the acrylic. [image] [image] (The ring was going to be used act as manual indicator on how much to index the dowl. But that didn’t work out as planned. I have another idea- But I wanted to press forward) Next st…

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled