Show me your HALLOWEEN stuff!

[evansd2]

Searching for “glass settings” found an answer pretty quickly:

https://community.glowforge.com/search?context=topic&context_id=30397&q=Glass%20settings&skip_context=true

From that search:

Help with engraving Glass - Settings (new)

I’m going to move this topic to Beyond the Manual. @tapoutms3, you can try the settings below for Engraving on glass: Power 100% Speed 850 LPI 340 You cannot cut all the way through glass with a laser though. Make sure you use a film of liquid dish soap, masking tape or a damp paper towel secured over the glass to keep it from cracking when you are engraving it.

And

Etching glass - settings

I successfully etched glass before the new settings took effect. Here are the settings I used and the results I got. To begin, I have heard the the cheaper the glass, the better the results with a CO2 laser like the Glowforge. You won’t get nice results on pyrex like you do on a cheap frame from the dollar store, like these. First, I masked the glass; though others suggest a thin layer of dish soap is effective and easy to clean up. [IMG_8286] Weeding little bits… good thing I have a box o…