3D Printer for Metal Clay: the Mini Metal Maker

I admit I am biased. My suggested printer is the CEL Robox. This printer has mediocre reviews on Amazon. My experience with the printer is much different. I run four of them and use them to provide 3D printing services through 3D Hubs. The number of prints I have fail due to a printer problem is about 1 in 100. I cancelled my filament recycling machine because I don’t generate enough scrap to justify the purchase of the recycler.
The printer is designed to be easy to use and while the build volume is smaller than some, it prints 95% of what my customers ask for. I have had several customers express disbelief that their parts had been 3D printed due to the consistent quality of the printer.
The printer uses a dual nozzle design to allow you to print draft prints or fine detail prints without needing to change hot ends. There is also the option to do a combined profile where you can use both nozzles in the same print, speeding up your print time by up to twice as fast, due to the ability to not print infill in every layer.
The filament flow is monitored from reel to print head so that if there are issues with filament movement the printer will automatically stop the print, attempt to fix the flow issue, and resume. If it is unable to fix it, it will pause until you can sort the problem and then will continue. This also reduces failed prints due to the material running out since it will stop the print if it runs out of material and wait until you load more material.
Dual materials are an option at extra cost.
The printer also comes with a 1 year warranty in the US, something that is hard to find. All US service is done in Arizona and the response time for support is usually within 30 minutes.
I run the support center and have been using the printers for about 2.5 years. In that time, other than consumables like the print head and extruder, I haven’t had to replace a part that wasn’t covered under the warranty.

1 Like