7 layer Eagle

Made on a Glowforge
1

Well…my spring break is over but I was able to produce 1 more multi-layered piece before I get back to the grind tomorrow.

I put some feelers out earlier this week and received a few requests for an Eagle scene and a river scene, so I tried putting them together. This was my first attempt at a river scene, and also splitting my multi-layers between left/right and up/down. This was a hair puller and multiple trial pieces found the garbage but felt very rewarding in the end.

As always, this one is capable of being cut in 1 pass on my GF basic. Instructions included in the purchased files.
Height is 15.5"
Width is 12.5"

Hope you all like it.
Enjoy.

1
1612×816 206 KB
2
2612×816 200 KB
3
3612×816 186 KB
4
4612×816 158 KB

34 Likes
2

Oooh - that’s lovely! The tiny bridge makes me smile :smiley:

2 Likes
3

The bridge illusion is probably the best part. It actually feels very different than anything I’ve seen before, not sure why. Really epic effect on there @armyclark

4 Likes
4

Your are so creative. I always love to see your art.

2 Likes
5

Utterly gorgeous.
bridge is over the top :upside_down_face:

7 Likes
6

You certainly have the layered stuff down. Each project is really wonderful!

2 Likes
7

I like the standing eagle shape. It makes a nice change from the usual eagle in flight.

2 Likes