Acrylic cuts

[jamierussell]

Has anyone cut half inch acrylic? If so does the material need to be flipped or will the gf cut all the way through both problem?

[caribis2]

One person here cut 3/4" acrylic without flipping, but the cut edge wasn’t exactly pristine. Enough passes and you’ll get through it.

[marmak3261]

1/2" Cast Acrylic

I had a need to made some parts out of 1/2" clear cast acrylic. I bought the material from Inventables using my GlowCredit, and after a few stabs in the dark, wound up with this mess: [MVIMG_20171031_202744] And, the first fire I had to put out. It was time for something more methodical. I give you: [Untitled-1] These are single line, 1/2" in length cuts at various focal depths and cutting speeds. All are at 100% Basic Power. .433" at 100 GlowySpeed gave fairly consistent cuts completel…

I have had good success following this topic.