Acrylic settings

[evansd2]

@jamesdhatch did a good write up on a very thorough method to dial in cut settings.

Dispatches from the front (Pre-release Report) - Cut Calibration

So one of the first things I usually do on a laser is to run calibration projects on them. But the Glowforge is a bit different from what I’m used to with Proofgrade materials and auto-magic settings for cuts, engraves and scores. When I got the PRU I followed the directions in the user manual (figured I should since it would be embarrassing if I broke someone else’s machine or reported a “problem” only to get a “we mention that on page 7 of the user manual” response to a support request …