And, to round things up, you can use the auto trace function of the Glowforge itself to generate a cut line. Just put your printed image in the bed of the Glowforge, click on Trace, and after the preview shows up, drag a square around the image and click just outside the image. When you Place Artwork and go back to the home page you should see on the left side a cut operation and an engrave operation. You can set the engrave operation to Ignore and use the Cut to cut out your image. (Note that if you are trying to cut around the same item you just traced, you should do it right under the camera and it might still be a bit out of alignment. You can try this process to tweak the image placement if necessary).
3 Likes