Adjust the power of the laser

I want to cut a plotter film that has been mounted on a glass, but how can i adjust the power of the laser?

Select Manual and the needed power level. 0-100 or Full Power. Different settings selections depending on whether you want Cut or Engrave.


Thanks, that’s exactly the attitude I was looking for.:grinning:

please be aware that many films sold for plotters are PVC-based, and should not be processed with a laser!

Thanks @rpegg for the assist regarding manual settings.

Unfortunately, we can’t offer support for materials that were purchased from another company and if your prints don’t come out as expected. I’m going to move this to Beyond the Manual so other folks here can continue to help. Should you have questions regarding printing on Proofgrade materials, please open a new ticket in Problems and Support and we’ll help you right away!