Did plenty of digging, but all the existing topics were closed. Simply wanted to report that a shellac and Arm-r-seal prefinished piece of walnut works very well on the Glowforge. No issues noticed and the engraving came out very clean
31 Likes
Thanks!
Thanks for sharing, did you use tape over this when engraving?
No, that is straight out of the machine. We used the proofgrade walnut settings, and the lettering is 100% black, no grays. The scale on that is about 3" across (whole picture).
1 Like
Thank you for confirming! I always feel like I have to mask everything.
Good to know! Thanks!