I’ve searched and searched, but haven’t been able to find settings for cutting and engraving 3/32” basswood. Trying again here, hoping someone else has used it!
P.S. Before someone says it, I don’t have enough material to sacrifice with tests. 
So fingers crossed someone has already figured out settings. TIA!
I haven’t cut it before but you’re only 1/32 away from 1/8 so if it were me i would use the pg settings for medium basswood. Since it’s not quite as thick, it should easily cut through… see if others have done it:-) Good luck!
This makes sense ~ thanks for the recommendation.
Are you sure? A material test takes just a small strip of the piece. Check out #6:
If you’ve already seen that and don’t even have that much to spare… hmm good luck 
And maybe 2 cuts? Just make sure it is masked well.