Can you bypass the preparing your print and autofocusing pre check

[evansd2]

@ekla

If you don’t lift the top lid

Or if the Glowforge doesn’t know you opened it.

Print with front passthrough slot open

Bypassing the front door open warnings can be done by using magnets to trick the sensors into thinking that the lid and sensors are in proper alignment (lid-mounted sensors and door-mounted magnets), or you can simply install a bypass jumper that tells the sensor circuitry that the door and lid are properly aligned. If you’re interested in attaining a set of bypass jumpers (non-invasive to the Glowforge wiring and fully reversible) message me for more info.

Be careful out there.