Hey there, the settings I used were:
600 speed, full power and 450 lpi. I can’t remember if I measured them or just did “set focus” but then I color them in with either a sharpie or with acrylic paint 
Great, thank you!
1 Like
No problem at all! Those settings have worked well for me on normal white tiles, but if you seem to have any issues, just message me
1 Like
Hello, I’m struggling with the settings on 1/4 in house tile. Suggestions? It’s etching at 400 power & 225 lines but it’s barely visible. Help!
We can only discuss settings for non proofgrade materials in the Beyond the Manual section of the forum. If you search that section you will find a wealth of information regarding engraving ceramic tiles. Here is a thread that has lots of good info: Etching Tile
1 Like