Cold climate exhaust set up?

[marmak3261]

I took the bottom window out and replaced it with foam board and taped it up with duct tape. then I cut a hole in the foam and had a plug I could put in and take out as needed.

Prototype Quick Disconnect Magnetic Vent Hose Coupler

I really was caught unprepared to physically receive a Glowforge. I was ready in terms of design ideas, workflow and materials but other than putting the exhaust hose out a window, I didn’t really picture what I was going to do. Luckily the few weeks before I had transformed the basement office into a work room and had picked up the table and gave a few thoughts to the window situation. I procured a piece of Celotex from a parishioner and used a 28 oz. tomato can to pierce the two layers of Cel…