Countersink holes in acrylic?

[kids_a_pistol]

Has anyone with a or prior experience tried engraving countersink holes in acrylic? Would the engrave time alone be counterproductive if you own a drill/press? Just laser some holes and countersink after? Thoughts?

[karaelena]

Pre-Release | Structure

Over the weekend I scored an new iPad Mini in trade for some IT work. I didn’t really check what model it was until I got home (Would have done it for free- but they insisted). Then I realized it was better (newer) than the iPad I already had. In which it had a iSense (a rebranded occipital structure) strapped to it. I temp connected the scanner to the newer iPad and immediately noticed the performance difference between the two. When I got the iSense- I got with the the mount for the iPad I al…

[kids_a_pistol]

I missed that part. Thank you!

[jamesdhatch]

Yes. Not on a GF though. Just did that for acrylic plates used to cover the RFID antenna for an electronic door lock install at my MakerSpace. Could it have been faster with a drill press? Probably a bit. But a laser

One good thing with the laser is that it’s dead spot on where you want it. And you won’t crack a corner because you placed it too close to the corner as you might with a drill (DAMHIK).

[Jules]

Happy Cakeday!

[rodrigobrionesm]

Happy Cake Slice day!!