Hello everyone,
Does anyone know what would be the best setting to cut 1/16 inch Baltic birch?
1 Like
10 Likes
Check out #6, it’s a great test method to get it exactly right.
9 Likes
Yeah, what they said - but also, it has been asked before (I searched for 1/16 and then scanned and found this):
10 Likes
Discussions about non-proofgrade settings belong in the Beyond the Manual category. I’ll move this over there for you.
8 Likes
In the past, I have used the GF settings for thick cardboard.
3 Likes
Three lower power passes that are quick can decrease the potential for burning, where a higher power cut that is also slower could create issues? I don’t know
. I just got some 1/8- thickness plywood and I am wondering about the settings for engrave and cut too.
1 Like
This topic was automatically closed 32 days after the last reply. New replies are no longer allowed.