Deep Dive into Sketching Inside of Fusion 360

Everything Else
,
1

Hey Everyone!

I’ve received a lot of feedback requesting a deep dive into sketching within Fusion 360
So, I’m going for it and am hosting a live webinar TOMORROW Dec 8, 2017 3:30 PM Mountain Time
I’m calling it part 0 because it is going to start off even more basic than any of the previous webinars. You can call it a prequel.

Register in advance for this webinar:
https://autodesk.zoom.us/webinar/register/WN_vAJaQfwTSj6ORvhQNYKmRg
After registering, you will receive a confirmation email containing information about joining the webinar.

Of course, I’m going to post a link to the recording after.

Hope you all can make it.

Warmly,

Jason Lichtman
Technical Specialist - Fusion 360

21 Likes
2

Thank you! Registered and on my calendar.

3

Wish I were available at that time tomorrow.

I’ve just started getting serious about learning Fusion 360 as my primary tool for GF designs. While I love the tool, I sure wish there was an easy way to export SVG of all of the pieces to be laser cut. For example, sketching a dove tailed box is relitivly easy, but having the export each of the parts to DXF and then convert them to SVG is not the smoothest workflow.

Good luck with your webinar!

4

Thank you for putting this together! I look forward to it!

5

Already registered. I’ve played a bit with Fusion 360, but I always learn something I didn’t know with refresher courses, so bring it! :sunglasses: :+1:

And somebody please remind me tomorrow…I lose track of time so easily…it’s already December. How the heck did that happen?

1 Like
6

dang, I’ve had conflicts with every one so far. Thanks for recording them.

7

Is there somewhere we can watch the recorded webinars?

8

Hey Jason,

thank you so much in advance for posting the link to the recording!!!

I will be on the road at that time.

Chris

9

Webinar #00 took place LIVE on Friday December 08th from 3:30- 4pm MST
Webinar #00 focused on:

  1. DEEP DIVE INTO SKETCHING

The official recording for Webinar #00 is available at: Fusion 360 for Glowforge Users - Part 00 of 06

8 Likes
11

Finally got around to watching your webinars. The snow and temps have given me a little extra free time. Thanks for all your hard work. Used Fusion 360 sparingly in the past but your series has significantly improved the experience.

Seems you have fallen off the forum for the past month. Any plans to continue the planned series?

1 Like
12

Almost ready for the next 3 webinars. There is a lot of prep involved and I’ll admit that I’ve been quite busy. I’ll be ready in about two weeks

4 Likes
13

I have no illusions that you just slap these together. Thanks for doing this.

2 Likes