I don’t quite understand, can you provide a screenshot?
this is the screen it has been on for over an hour now. no test cutor print. the laser head is ion the home position. a pop-up window came up in the bottom right of the screen that said my camera has been calibrated or aligned. I clicked on the “X” on the box and it disappeared. But that was twenty mins ago, with nothing else happening. I am assuming I will need to start over.
My point being that on the first attempt, it states it is only 75% complete, and it didnt budge off of that status . . . just wanted to clarify… And also, I have attempted the test again and it says it is being interrupted. Internet stays full signal throughout the whole test. Not sure why it will not complete. this is the results of the 3rd attempt.
