Enterprise WPA

[karaelena]

I asked this question a couple days ago.

How does the app connect to the glowforge?

@dan I was going to create a new topic for this question, but think thread would be a better location to ask. What wifi protocols does the GF support? 802.11a/b/c/n? (with ac?) and does it support WPA/WPA2 (or enterprise networks that support username/pass?) Is WEP supported ? (I hope not) And is there a threshold where if the speed negotiated is too low (i.e. 802.11b @ 5.5Mbits) a job will not go thru as in hard fail and throw an error? And how does the GF handle weak / spotty connections? How…

@dan replied below my post.